linuxdebug/Documentation/ABI/testing/sysfs-bus-iio-sx9324

30 lines
1.1 KiB
Plaintext

What: /sys/bus/iio/devices/iio:deviceX/in_proximity<id>_setup
Date: November 2021
KernelVersion: 5.17
Contact: Gwendal Grignou <gwendal@chromium.org>
Description:
SX9324 has 3 inputs, CS0, CS1 and CS2. Hardware layout
defines if the input is
+ not connected (HZ),
+ grounded (GD),
+ connected to an antenna where it can act as a base
(DS - data shield), or measured input (MI).
The sensor rotates measurement across 4 phases
(PH0, PH1, PH2, PH3), where the inputs are configured
and then measured.
By default, during the first phase, [PH0], CS0 is measured,
while CS1 and CS2 are used as shields.
`cat in_proximity0_setup` returns "MI,DS,DS".
[PH1], CS1 is measured, CS0 and CS2 are shield:
`cat in_proximity1_setup` returns "DS,MI,DS".
[PH2], CS2 is measured, CS0 and CS1 are shield:
`cat in_proximity1_setup` returns "DS,DS,MI".
[PH3], CS1 and CS2 are measured (combo mode):
`cat in_proximity1_setup` returns "DS,MI,MI".
Note, these are the chip default. Hardware layout will most
likely dictate different output. The entry is read-only.