37 lines
1.3 KiB
Plaintext
37 lines
1.3 KiB
Plaintext
|
Nuvoton NPCM Peripheral Serial Peripheral Interface(PSPI) controller driver
|
||
|
|
|
||
|
|
Nuvoton NPCM7xx SOC support two PSPI channels.
|
||
|
|
|
||
|
|
Required properties:
|
||
|
|
- compatible : "nuvoton,npcm750-pspi" for Poleg NPCM7XX.
|
||
|
|
"nuvoton,npcm845-pspi" for Arbel NPCM8XX.
|
||
|
|
- #address-cells : should be 1. see spi-bus.txt
|
||
|
|
- #size-cells : should be 0. see spi-bus.txt
|
||
|
|
- specifies physical base address and size of the register.
|
||
|
|
- interrupts : contain PSPI interrupt.
|
||
|
|
- clocks : phandle of PSPI reference clock.
|
||
|
|
- clock-names: Should be "clk_apb5".
|
||
|
|
- pinctrl-names : a pinctrl state named "default" must be defined.
|
||
|
|
- pinctrl-0 : phandle referencing pin configuration of the device.
|
||
|
|
- resets : phandle to the reset control for this device.
|
||
|
|
- cs-gpios: Specifies the gpio pins to be used for chipselects.
|
||
|
|
See: Documentation/devicetree/bindings/spi/spi-bus.txt
|
||
|
|
|
||
|
|
Optional properties:
|
||
|
|
- clock-frequency : Input clock frequency to the PSPI block in Hz.
|
||
|
|
Default is 25000000 Hz.
|
||
|
|
|
||
|
|
spi0: spi@f0200000 {
|
||
|
|
compatible = "nuvoton,npcm750-pspi";
|
||
|
|
reg = <0xf0200000 0x1000>;
|
||
|
|
pinctrl-names = "default";
|
||
|
|
pinctrl-0 = <&pspi1_pins>;
|
||
|
|
#address-cells = <1>;
|
||
|
|
#size-cells = <0>;
|
||
|
|
interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>;
|
||
|
|
clocks = <&clk NPCM7XX_CLK_APB5>;
|
||
|
|
clock-names = "clk_apb5";
|
||
|
|
resets = <&rstc NPCM7XX_RESET_IPSRST2 NPCM7XX_RESET_PSPI1>
|
||
|
|
cs-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>;
|
||
|
|
};
|