45 lines
1.4 KiB
Plaintext
45 lines
1.4 KiB
Plaintext
|
* ST-Ericsson DB8500 Thermal
|
||
|
|
|
||
|
|
** Thermal node properties:
|
||
|
|
|
||
|
|
- compatible : "stericsson,db8500-thermal";
|
||
|
|
- reg : address range of the thermal sensor registers;
|
||
|
|
- interrupts : interrupts generated from PRCMU;
|
||
|
|
- interrupt-names : "IRQ_HOTMON_LOW" and "IRQ_HOTMON_HIGH";
|
||
|
|
- num-trips : number of total trip points, this is required, set it 0 if none,
|
||
|
|
if greater than 0, the following properties must be defined;
|
||
|
|
- tripN-temp : temperature of trip point N, should be in ascending order;
|
||
|
|
- tripN-type : type of trip point N, should be one of "active" "passive" "hot"
|
||
|
|
"critical";
|
||
|
|
- tripN-cdev-num : number of the cooling devices which can be bound to trip
|
||
|
|
point N, this is required if trip point N is defined, set it 0 if none,
|
||
|
|
otherwise the following cooling device names must be defined;
|
||
|
|
- tripN-cdev-nameM : name of the No. M cooling device of trip point N;
|
||
|
|
|
||
|
|
Usually the num-trips and tripN-*** are separated in board related dts files.
|
||
|
|
|
||
|
|
Example:
|
||
|
|
thermal@801573c0 {
|
||
|
|
compatible = "stericsson,db8500-thermal";
|
||
|
|
reg = <0x801573c0 0x40>;
|
||
|
|
interrupts = <21 0x4>, <22 0x4>;
|
||
|
|
interrupt-names = "IRQ_HOTMON_LOW", "IRQ_HOTMON_HIGH";
|
||
|
|
|
||
|
|
num-trips = <3>;
|
||
|
|
|
||
|
|
trip0-temp = <75000>;
|
||
|
|
trip0-type = "active";
|
||
|
|
trip0-cdev-num = <1>;
|
||
|
|
trip0-cdev-name0 = "thermal-cpufreq-0";
|
||
|
|
|
||
|
|
trip1-temp = <80000>;
|
||
|
|
trip1-type = "active";
|
||
|
|
trip1-cdev-num = <2>;
|
||
|
|
trip1-cdev-name0 = "thermal-cpufreq-0";
|
||
|
|
trip1-cdev-name1 = "thermal-fan";
|
||
|
|
|
||
|
|
trip2-temp = <85000>;
|
||
|
|
trip2-type = "critical";
|
||
|
|
trip2-cdev-num = <0>;
|
||
|
|
}
|